technical ceramic solutions

What tests do ceramic heating elements have to do before they leave the factory?

Real-time data measured by infrared thermometer

What tests do ceramic heating elements have to do before they leave the factory?
1) Power-on test
2) Insulation resistance detection
3) Leakage Current Test
4) High-voltage insulation test
5) Peel force test
6) Temperature rise measurement
7) Life test
8) measurement
9) Appearance & Dimension test
10) Packing inspection
11) Other Special Requirements from customer

Here is some of our ceramic rod heater test video.
Video content:
1. Conventional power-on test
2. Power on test
3. Composite ceramics, lead does not fall off at 800℃ P1837
4. Life test
5. Temperature test (Temperature behavior at different voltages)
6. Real-time data measured by infrared thermometer
7. Infrared thermometer (range of 900 degrees), HHHH means out of range, over top 900℃
8. Power on the test, non-routine test
9. Power measurement, Innovacera hot surface igniter for Biomass Pellet Stove

Related Products

  • TO-220 Ceramic Insulator Cooling Pads

    TO-220 Ceramic Insulator Cooling Pads

    Innovacera TO-220 Ceramic Insulators were to be mounted between the TO-220 packaged power transistors and the heatsink, its dimensions is 14 x 20 x 1 mm (0.55 x 0.79 x 0.04in), the Mounting hole diame…

  • Alumina Ceramic Insulating Sheet & Aluminum Nitride Ceramic Insulating Sheet

    TO 247 Ceramic Insulating Sheet

    Innovacera TO-247 Ceramic Insulating Sheet is designed to optimize thermal management in discrete semiconductors, including MOSFETs, IGBTs, and transistors. TO-247 Ceramic Insulating Sheet is a high-p…

  • Silicon nitride grinding ball

    Silicon Nitride Grinding Media Balls

    Innovacera Silicon Nitride Grinding Media Balls was made by 3 forming way: titration, roll and CIP (cold isostatic pressing ) forming and they were gas pressing sinetering in 1800~2100℃.The purity of …

Enquiry